kevin phillips

Thanks for the part information , have a good day

I have a customer with a stuck switching valve on the frame rail, according to parts it is no longer available from ford. Picked one up from a local parts house but the lines are way off on connection points and of course you have to order a connector. They say it's a" universal" wondering if you guys have been there before and know of a direct bolt-on aftermarket component that don't require modification of those brittle plastic lines and the rewire job . part number is e9tb-9f271-aa on the actual part thanks for any info ,kevin

ty for the reply bruce,ended up being a ecu issue replaced with a scrapyard unit all is well now.

I have a 2003 jag with a mil on and codes p0327 p0332 knock sensor codes that reset within a minute without even driving and a reduced power message in cluster. I have limited info around on the jaguars and its a used trade in which the owner thinks is a keeper. Anyone have any experience on these or any pointers ? I don't see any issues with wiring and sensor connectors are clean at sensor and processor. leaning towards a ecu issue but looking for advice from the experts thanks for any help or advice Lincoln tests are way off connectors ect.

T he valve was not switching completly making return flow have issues

I bypassed the switching valve problem went away. M

It does have the dual tanks with the switching valve. Truck has been sitting awhile also like a year or so just put back in use

Have a 1991 f-250 with a idi non turbo 7.3 liter that keeps blowing the fuel return lines off. I have tried blowing air through the return line to tank and it is free and not clogged up. I have replaced the caps and lines still doing it usually when under load is when it happens or high rpm. Replaced clamps with worm gear style then it split a line so it seems to be getting excessive pressure in the return system. Any ideas or areas u guys have seen cause this? thanks for any replys

updated pcm with latest ids calibration,and replaced iac which was the culprit thanks all for the help

low pressure fuel pump fixed concern thank you alex

Have a 2011 f350 with a code p054e which occurs every third or forth road test.I have ran ppt-m several times with no problem seen.contacted hotline was told the air filter sometimes causes this code but the air filter is clean and correct .Anyone ran into this before or have any pointers?I'm in a small dealer with very few issues so far with the 6.7 other than def fluid issues codes ect thanks for any help

tyvm that is the one I think I remembered just was unable to locate.

Anyone remember the tsb for these engines where they were flooding and not starting at times? The problem is very infrequent and I have only made it do it once had to put in clear-flood mode to get it to start. Fuel pressure was in spec when tested during concern Any ideas?

kk ty keith for looking will check it out

I have a 1999 7.3 f-350 drw truck in need of the aft axle fuel tank.the fuel tank is rusty beyond repair and the ford unit parts says is no longer available.What are you guys using for a replacement? i am not having any luck finding a oem style replacement that will work.Anybody know a place or link thank you