robp823

I have a 6NZ in a kenworth that will miss intermittently.Its not logging any faults.Ran injector test and passes.Pulled valve cover and checked overhead, no issues.Had a fuel pressure gauge and road test.Fuel pressure was good.Any thoughts?

What year DT? I can help you out.

Been away from the ford dealer for a while.Do I need a scan tool to bleed the abs on this?Replaced a caliper that blew apart from not changing the brakes.bleed brakes and can barely get a pedal.thanks.

Yea you guys are right.Really appreciate all the help.Thanks.

Well the guy is a good friend if mine and is looking for a quick fix to dump the truck.What are your thoughts on changing the lifters if the cam is not destroyed and I drop the pan and the bearings are ok? In my mind the engine is pretty much fucked but man do I feel bad he just dumped 5800.00 in this thing.

Thoughts opinions ? Shat do you guys think is coming apart? Lifter needle bearing?

Inside

Well doesn't look good.

thanks guys.Ill let you know what I find.

The high pressure pump was done 2 months ago.Im hoping they put an updated fitting on when they had it apart.Anyway best way to tear this apart???Tear the whole front apart or just pull the rad???

A friend of mine asked me to look at his truck.He said it just died.06 6.0.I looked at it yesterday.Cranking the engine the gauge doesnt move for oil pressure.I removed the oil filter and held the check valve down and cranked again.Its not filling the oil filter housing.I removed the oil pressure switch and put a gauge on there and i have 0 psi.Removed the regulator i found 2 tiny peices of metal that looked like part of a wire wheel but thats it.Oil looks clean.Is it safe to say i need to go after the LP pump.Also whats the best way to remove its been a while since i worked on a 6.0.I work for International now and its Maxxforce all day everday.

Fault codes 143 and 147.

Cranks fine.Have battery charger hooked up.After about 3 seconds of cranking the faults set.It does not sound like it wants to fire.

I keep getting codes for for cmp and ckp incorrect signal signature.Ive load tested both circuits and checked for shorts.Everything checks out fine.Ive tried a cmp sensor,ckp sensor, and a test ECM.It still will not fire.I did notice when I pulled the cmp sensor out it had metal shavings all over it.So I scoped out the sensor bore.I can see the timing peg on the cam and don't see any damage.Is it possible that one of the gears slipped out of time??? That's where im at.Any help appreciated.

They did a platinum kit.As far as I know all the parts are correct and the injectors were programmed.I was curious to that myself because I recently found out that the turbos are different on higher horsepower models.The truck does have the correct turbo installed.