blackop555

Wire harness fixed it.

Did you ever solve this

Not recommended to overlay pcm to ficm?

I meant ficm not the f word sorry already swapped a know good one.

05 f250 intermittently when hot vehcile will keep cranking and not start whennit does this engine sounds like it's bucking against the started shut key off and retry fires right up no codes at all. Customer replaced cam sensor. Usually happens after a good run shut off and try to restart quickly it happens and every start after engine bucks started but starts but sometimes has a very long bucking episode until I turn key off and retry. When this happens icp is food ipr cycle at 30 sync reads yes and fuck sync says no cam fault says no fuel desired reads during this time. I swapped in a known good pcm and fuck and it still does it. So random its hard to diag. Help

Clear code perform ppt m no problem found few days later comes back. Went ahead and tests pcv and vcv as per wsm no leakage found. At a loss

tryed new idm codes went away after driving codes came back. kept swapping injectors with known. i take it injectors are bad and are taking out the new fidm.. also did compression again for cylinder 8 contribution code and all compression was around 400 and cyl 8 was around 350. never seen one this mild. think this is cause for concern with the blue smoke?

Truck is a 01 f350 When vehicle is under 170 degrees oil temp vehicle has blue smoke. Starts bad and gradually lessons at 150 only has smoke on high rpm acceleration then at 170 it stops and truck is fine. Checked codes had codes for 2 qnd 8 high to low open on injector buzz test few sounded week. Wiring from Idm to uvc was good uvc to injectors were good. So I replaced idm no more circuit codes. Let vehicle warm up and perform contribution and cylinder 8 and 3 was low. Pulled covers and checked compression. They were around 425 when warm and 400 when cold. Replaced injectors. Road tested got air out of system and noticed check engine light randomly coming on and would go out on heavy accel. Come on when you cut back on the foot feed. Checked codes and I have cylinder 8 and 3 contribution still. Buzz test shows high to low open on 2 4 and 6. Checked wiring again all is good. Uvc shows each injector at 2.8-3.1 ohms. What should I do.

another thing with the core supports i had one rub out but i could not see any rub through the wire loom sheeth but as soon as i cut it away i found my wire with a big rub mark. it was for fuse 40 by the way. left core support. red wire i believe

have to agree with mr clayton on this one.

thats what i was thinking. was clicking as well?

just finished headgasket job after i got done so after going on my road test i came back and had to move it from my stall to do another one. so when cranking i noticed a loud click every few revolutions of the engine and when it finally fires up you can hear a whine like the starter is still engaged. what do you think about the clicking noise when cranking. faulty starter?

Yeah unplugged it and it fired right up power balance was fine minus #3 with injector plugged in the power balance was erratic at best and the vehicle would.stall after a bit of running. Unplug the injector and it would run all day no random engine cutting out and back in like only having icp unplugged

My guess would be back feeding thru ficm to pcm if internal short. Or else it was shorting through the oil rail and feeding through the icp sensor causing the pcm to freeze up as experienced by the ids. I could be wrong

Found the problem. Was an 04. The issue was a internally shorter fuel injector back feeding somehow. Cylinder 3