amailloux Posted December 23, 2013 Share Posted December 23, 2013 I have a split line about 3 inches from the secondary fuel filter tee. I have the new assembly sitting here, and it looks like I can remove the line on the new one and install it on the old line. Has anyone done this, I cut the old line off of the barb at the tee that goes to both sides of the engine and the injectors. I don't want to ruin the new assembly by taking it apart, but I also don't want to replace the entire assembly if it is a quality repair just replacing the damaged section. Quote Link to comment Share on other sites More sharing options...
lmorris Posted December 23, 2013 Share Posted December 23, 2013 We have done it successfully. Use a heat gun for removal and installation. Quote Link to comment Share on other sites More sharing options...
amailloux Posted December 23, 2013 Author Share Posted December 23, 2013 I applied a small amount of heat, slid it off, lubed it and slid it on. there is no way it will come off again. I can't even rotate it. I feel comfortable with the repair. Thanks lmorris. Quote Link to comment Share on other sites More sharing options...
lmorris Posted December 23, 2013 Share Posted December 23, 2013 Your welcome. For future reference, you can get just the tee by itself. We have had a few broken during filter replacement. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.